New member first post
15 posts
• Page 2 of 2 • 1, 2
Re: New member first post
by ack1 » Sun Oct 16, 2016 2:07 pm
First post, running mach3 on one machine and multicam original on another. Looking to switch on both.
- ack1
- Posts: 8
- Joined: Sun Oct 16, 2016 1:29 pm
Re: New member first post
by bvbang » Tue Oct 18, 2016 8:06 am
First post, just started learning UCCNC with UC300ETH.
- bvbang
- Posts: 1
- Joined: Tue Oct 18, 2016 7:59 am
Re: New member first post
by AndyB » Thu Oct 27, 2016 3:47 pm
First post for me too.
Using a UC100 + UCCNC to run a router. Second router in process. CNCzone name is "Banduramaker"
Using a UC100 + UCCNC to run a router. Second router in process. CNCzone name is "Banduramaker"
- AndyB
- Posts: 3
- Joined: Thu Oct 27, 2016 3:31 pm
Re: New member first post
by jfong » Mon Oct 31, 2016 5:19 pm
Running Uccnc/uc300eth/lpt5 for the past two weeks. No problems whatsoever. Big performance upgrade from Mach3/parallel port that has been running my Cnc for 3 years.
Long time cnczone member. Joined here to check on updates.
Long time cnczone member. Joined here to check on updates.
- jfong
- Posts: 1
- Joined: Sun Oct 30, 2016 3:02 am
Re: New member first post
by AL-H » Thu Jun 15, 2017 2:58 pm
My first post also.
Running UCCNC+UC300_5LPT, Really like it.
Running UCCNC+UC300_5LPT, Really like it.
- AL-H
- Posts: 5
- Joined: Fri Mar 17, 2017 5:27 pm
15 posts
• Page 2 of 2 • 1, 2
Return to General discussion about the UCCNC software
Who is online
Users browsing this forum: No registered users and 23 guests