Is quadrature encoder lathe threading supported in UCCNC with a UC400ETH board?
Is the Mach 4 plugin using quadrature inputs or single index pulse for lathe threading?
Quardrature threading questions
2 posts
• Page 1 of 1
Quardrature threading questions
by bpratl » Fri Feb 23, 2018 10:47 am
UC400ETH,W7 - lathe G0602
UC300ETH/M44B/C62 - mill G0619 - 4 axis (in process)
UC300ETH/M44B/C62 - mill G0619 - 4 axis (in process)
- bpratl
- Posts: 12
- Joined: Fri Jun 03, 2016 9:29 am
- Location: Gloucester, MA, USA
Re: Quardrature threading questions
by cncdrive » Fri Feb 23, 2018 11:34 am
Yes, G32 simple thread cutting and G76 complex thread cutting codes are supported in the UCCNC and the syncronisation can be done with the spindle incremental encoder. Single index only mode is not supported, only incremental A, B and Index is supported.
No, our Mach4 plugins do not support thread cutting at all with Mach4. We could not make that function to work in Mach4.
No, our Mach4 plugins do not support thread cutting at all with Mach4. We could not make that function to work in Mach4.
- cncdrive
- Site Admin
- Posts: 4887
- Joined: Tue Aug 12, 2014 11:17 pm
2 posts
• Page 1 of 1
Return to General discussion about the UCCNC software
Who is online
Users browsing this forum: No registered users and 17 guests