I just need G41/G42.
Have no use at all for the others you mentioned.
ger21 wrote:I just need G41/G42.
Have no use at all for the others you mentioned.
Vmax549 wrote:Here are some of the gcodes I still miss when running UCCNC. NOT in any specific order
Parametric Gcoding as G1 X[#1 * 2.035] where teh axis call is a calculation or X- [#1*2.035] where teh - is a directional call
What things are you guys missing ??????
(;-) TP
Return to General discussion about the UCCNC software
Users browsing this forum: No registered users and 9 guests