First of all, I'm new to UCCNC and Fusion360, so maybe this is a stupid question, but here it goes:
I have made this simple model (see attached pic) in Fusion, made a 2D contour, with zero point (WCS) at the left side corner, generated the toolpass using the Generic UCCNC Post Processor.
- Fusion
Then I load the .nc file in to UCCNC, but now the zero point is in the middle of the model !!! (See attached pic)
- UCCNC
How do I correct this, so I have the zero point at the same place in both Fusion and UCCNC ??
Thanks in advance
Best regards
Jens J. Larsen
Vodskov
Denmark