Hello,
is it there a way to try the UCCNC in demo mode with real hardware? I have an AXBB-E that I'm using with Mach3, but would like to make some test before buying the new software.
Nothing like a "5 minute full feature" demo mode?
Looking forward to your help!
Best Regards,
UCCNC demo mode
3 posts
• Page 1 of 1
UCCNC demo mode
by scubalemur » Wed Feb 19, 2025 3:59 am
- scubalemur
- Posts: 1
- Joined: Wed Feb 19, 2025 3:55 am
Re: UCCNC demo mode
by cncdrive » Wed Feb 19, 2025 4:12 pm
No, it is not possible.
UCCNC in demo mode does not connect to the motion controller at all, in demo mode it emulates everything on the computer.
How the UCCNC licensing works you can read under point 1.6 of the UCCNC users manual.
UCCNC in demo mode does not connect to the motion controller at all, in demo mode it emulates everything on the computer.
How the UCCNC licensing works you can read under point 1.6 of the UCCNC users manual.
- cncdrive
- Site Admin
- Posts: 5027
- Joined: Tue Aug 12, 2014 11:17 pm
Re: UCCNC demo mode
by elenagilbert » Thu Feb 20, 2025 7:25 am
UCCNC does offer a demo mode, but it does not allow real hardware control, only software simulation. Unfortunately, there is no 5-minute full-feature trial that enables actual machine operation.
Buckshot Roulette
Buckshot Roulette
- elenagilbert
- Posts: 4
- Joined: Sat Feb 08, 2025 8:56 am
3 posts
• Page 1 of 1
Return to General discussion about the UCCNC software
Who is online
Users browsing this forum: Bing [Bot] and 13 guests