step/dir spindle CA servo motor T6 1000w from stepperonlin

[carpa1970]

Hi,today I tried with the hall sensor, same result! this is the Gcode:
g17 g49 g90 g21
g54 g0 x0 y0
z5
s100m3
g33.1 z-10 k1
g80
g0 z5
m5 m9
m30
maybe this is the problem?
the video, entitled "with servo index", I think I have finally made it public, then, I add a second video entitled "with hall sensor", it changes, perhaps only the LED index on time on axbb.
https://youtube.com/shorts/P0Jw16oazDU?feature=share

[dezsoe]

Try to toggle the "Reverse enc. dir." setting: the G33.1 (and other synch motions) also check for the direction read from the spindle.

[carpa1970]

thank you guys! I don't know if it's my laptop's fault but I changed it with another one and everything works! with the servo motor encoder!

[mbrown]

I'm currently converting a manual Warco mill to CNC, and have all the axis functioning with nema 24 and 34 closed loop steppers connected to an AXBB-E motion controller. The spindle is the next item to convert and am considering the Stepperonline T6 Series 1000W AC Servo Motor Kit 3000rpm 3.19Nm. Does anyone have an experience with these drives and their suitability? I'm assuming the only way to run these is using step/direction outputs from the AXBB-e controller? Carpa1970 How did you get on with yours?
https://www.omc-stepperonline.com/t6-se ... 0h2a3-m17s