What is the recommended method for upgrading UCCNC?
Just install over the top? Uninstall before a new install?
UCCNC?
3 posts
• Page 1 of 1
Re: UCCNC?
by eabrust » Fri Apr 19, 2024 2:01 pm
salmawisoky wrote:What is the recommended method for upgrading UCCNC?
Just install over the top? Uninstall before a new install?
My preference is keeping multiple versions installed at the same time. Install the new versions in separate folders such as UCCNC2115, UCCNC2217, etc...
Then you can fall back if needed, and have something to go back to as a backup.
After installing the new version, just copy the profile folders, license, any plugins, etc to the new, and use shortcuts to open the version you want to run.
Once you're really happy with the latest version you're using, then you can uninstall/delete the old folder if you need for disk space (which is hardly anything).
regards
Eric
CraftyCNC: Plugins for UCCNC (and other neat stuff): http://www.craftycnc.com/plugins-for-uccnc/
- eabrust
- Posts: 357
- Joined: Fri Sep 16, 2016 2:32 am
- Location: Near Shirland IL, USA
3 posts
• Page 1 of 1
Return to General discussion about the UCCNC software
Who is online
Users browsing this forum: No registered users and 38 guests