AXBB-E
3 posts
• Page 1 of 1
AXBB-E
by christos76 » Tue Feb 13, 2024 4:46 pm
hello my friends. I'm not very relevant so I'm asking for any help you can give me. I have an AXBB-E and the UCCNC. I've been working with it for a long time now without a problem but since yesterday my motors refuse to run, which are nema34 closed loop .I don't know it happened suddenly. Everything is fine, I don't know why they stopped running suddenly. As far as I know, I have checked and it is fine. If you could help me please.
- christos76
- Posts: 2
- Joined: Sun Aug 06, 2023 10:53 am
Re: AXBB-E
by cncdrive » Wed Feb 14, 2024 4:56 pm
Do your motor have holding torque?
I mean if they are powered can you rotate the motor shaft or it holds against?
I mean if they are powered can you rotate the motor shaft or it holds against?
- cncdrive
- Site Admin
- Posts: 4887
- Joined: Tue Aug 12, 2014 11:17 pm
Re: AXBB-E
by christos76 » Thu Feb 15, 2024 9:11 pm
All good. Problem solved.. Thank you for your interest.
- christos76
- Posts: 2
- Joined: Sun Aug 06, 2023 10:53 am
3 posts
• Page 1 of 1
Return to General discussion about the UCCNC software
Who is online
Users browsing this forum: No registered users and 36 guests