I don't think they'll be starting it until after the next full version release. So still another 6-12 months away, probably.
Just guessing on my part, though.
acceleration curves
32 posts
• Page 4 of 4 • 1, 2, 3, 4
Re: acceleration curves
by ger21 » Mon Apr 22, 2019 11:31 pm
Gerry
UCCNC 2022 Screenset - http://www.thecncwoodworker.com/2022.html
UCCNC 2022 Screenset - http://www.thecncwoodworker.com/2022.html
- ger21
- Posts: 2714
- Joined: Sat Sep 03, 2016 2:17 am
Re: acceleration curves
by cncrouterinfo » Tue Oct 18, 2022 8:01 pm
After following this for years, I'm almost afraid to ask if there is an update regarding this.
- cncrouterinfo
- Posts: 1
- Joined: Tue Oct 18, 2022 8:00 pm
32 posts
• Page 4 of 4 • 1, 2, 3, 4
Return to General discussion about the UCCNC software
Who is online
Users browsing this forum: No registered users and 24 guests