macro m6

[kjetil]

Hello.
I have just built a new cnc and bought a controlbox from cncdrive.
I also bought a 3d touch probe from cncdrive and a bitsetter from them.
can anyone help with setup in uncnc software.
some macros need to be added to make these work. I want to set up so that every time I change tool I can run a macro so that zero point is set with the help of bitsetter.

[A_Camera]

I think you need to be more specific about what you need help with. The installation of UCCNC is pretty simple, configuration for a machine is also pretty simple, just follow the manual. I don't know which 3D probe or tool setter you have and what the problems are, but I think if you want people to write specific macros for your machine and your needs then that might not be free of charge since time is money for everyone except a few. Anyway, you must show some effort, try to figure out on your own using the manuals provided. There are also many free macros which can be downloaded, modified and reused to fit your needs. Anyway, it's easier to help if you specify what you need help with, to me it is not entirely clear.