Solidworks 2022( Delmia) Post processor, what do people do?

[Zed_UCCNC]

What do people do for the new CAM software associated with Solidworks 2022( Delmia CAM)

It gives choice of many pre-written posts processors. None are UCCNC or Mach3/4. There is no mention of RS274NGC programming language, so that is not a choice either.

I think I saw some comments a long time ago that generic Fanuc posts would work for Mach3, but there are dozens of Fanuc machines listed.

So Is there any experience here with this?