Hi all,
homing Z axis:
1.2111: after homing the machine coordinates show "0".
1.2113: after homing the machine coordinates show any value, but not "0".
In both cases the Z-axis is at the top.
Am I making a mistake?
Peter
Problems with homing Z-axis
4 posts
• Page 1 of 1
Problems with homing Z-axis
by CADdy » Mon Aug 02, 2021 8:29 am
- CADdy
- Posts: 148
- Joined: Sun Sep 17, 2017 2:26 pm
Re: Problems with homing Z-axis
by CADdy » Mon Aug 02, 2021 9:50 am
sorry, it is version 1.2112 not 13.
I'll test it with 1.2113 (new installation)
Peter
I'll test it with 1.2113 (new installation)
Peter
- CADdy
- Posts: 148
- Joined: Sun Sep 17, 2017 2:26 pm
Re: Problems with homing Z-axis
by Battwell » Mon Aug 02, 2021 10:57 am
in axis setup set auto set to zero. as standard the z is set to 50mm
Uc300eth on router and mill.
UK uccnc powered machine sales. https://cncrouter.uk/atc-cnc-routers.htm
Automateanything/duzzit cnc/mercury cnc
UK uccnc powered machine sales. https://cncrouter.uk/atc-cnc-routers.htm
Automateanything/duzzit cnc/mercury cnc
- Battwell
- Posts: 867
- Joined: Sun Sep 25, 2016 7:39 pm
- Location: South Wales. Uk
Re: Problems with homing Z-axis
by CADdy » Mon Aug 02, 2021 8:03 pm
Battwell wrote:in axis setup set auto set to zero. as standard the z is set to 50mm
You are right, that was it!
Many thanks
Peter
- CADdy
- Posts: 148
- Joined: Sun Sep 17, 2017 2:26 pm
4 posts
• Page 1 of 1
Return to General discussion about the UCCNC software
Who is online
Users browsing this forum: No registered users and 20 guests