v carve pro
5 posts
• Page 1 of 1
v carve pro
by jonathanmahnken » Thu Apr 08, 2021 5:02 pm
Will I have trouble working in inches with this program? They only have a post for uccnc(mm)...
- jonathanmahnken
- Posts: 26
- Joined: Wed Mar 31, 2021 5:32 pm
Re: v carve pro
by mickecarlsson » Thu Apr 08, 2021 8:49 pm
If your UCCNC is setup to work in mm then you can work in imperial in Vcarve and use UCCNC post processor for mm.
- mickecarlsson
- Posts: 52
- Joined: Mon May 11, 2020 2:42 pm
Re: v carve pro
by ger21 » Thu Apr 08, 2021 9:12 pm
You can also very easily create an inch post processor if you work in inches in V Carve, and have UCCNC setup in inches.
Gerry
UCCNC 2022 Screenset - http://www.thecncwoodworker.com/2022.html
UCCNC 2022 Screenset - http://www.thecncwoodworker.com/2022.html
- ger21
- Posts: 2714
- Joined: Sat Sep 03, 2016 2:17 am
Re: v carve pro
by charliem » Fri Apr 09, 2021 9:37 am
You can also use the Mach2/3 Arcs inch PP. This what I use and I have no issues.
Regards
Charlie M
Charlie M
- charliem
- Posts: 108
- Joined: Sun Jan 01, 2017 5:37 pm
Re: v carve pro
by jonathanmahnken » Sat Apr 10, 2021 9:01 pm
Thanks to eveyone. I discovered there is a standard gcode pp in inches for v carve.
- jonathanmahnken
- Posts: 26
- Joined: Wed Mar 31, 2021 5:32 pm
5 posts
• Page 1 of 1
Return to General discussion about the UCCNC software
Who is online
Users browsing this forum: No registered users and 26 guests