Nick
AXBB License
3 posts
• Page 1 of 1
AXBB License
by naijin » Thu Oct 01, 2020 5:45 am
Hi there, just installed the AXBB-E controller, down loaded UCCNC ver 1.211 copied the license into the UCCNC directory, but it still runs in demo mode.. any suggestions or ideas would be greatly appreciated..
Nick
Nick
- naijin
- Posts: 106
- Joined: Mon Dec 04, 2017 11:24 pm
Re: AXBB License
by thegreatwaldo » Thu Oct 01, 2020 6:53 am
Hi Nick
Make sure the license file numbers correspond to the controller serial. Cncdrive sent me the wrong license file once (fixed it it in 5 mins,)
Cheers
Andrew
Make sure the license file numbers correspond to the controller serial. Cncdrive sent me the wrong license file once (fixed it it in 5 mins,)
Cheers
Andrew
- thegreatwaldo
- Posts: 178
- Joined: Tue Sep 06, 2016 8:28 pm
Re: AXBB License
by cncdrive » Thu Oct 01, 2020 2:40 pm
Also make sure to setup the network card IP address as described in details in the AXBB-E manual.
- cncdrive
- Site Admin
- Posts: 4887
- Joined: Tue Aug 12, 2014 11:17 pm
3 posts
• Page 1 of 1
Return to General discussion about the UCCNC software
Who is online
Users browsing this forum: No registered users and 25 guests