Trochoidal cv settings?

[Demusman]

Trying out trochoidal milling and no matter how fast I set my feed the velocity stays around 30.
I'm guessing this is a CV setting.
Does UCCNC do trochoidal milling?
Is my guess correct?
Should I use exact stop?

[ger21]

Does UCCNC do trochoidal milling?

UCCNC just does what the g-code tells it to do.

Some people have run into issues where UCCNC will hesitate between arcs, which may be what you are seeing.
Try increasing your CV error tolerances and see if it helps. Faster acceleration can also help.