Rotate part.
12 posts
• Page 2 of 2 • 1, 2
Re: Rotate part.
by cncdrive » Sun Feb 23, 2020 6:15 pm
Yea, there are things which I often do not even remember that are in the software eventhough I programmed them.
- cncdrive
- Site Admin
- Posts: 4887
- Joined: Tue Aug 12, 2014 11:17 pm
Re: Rotate part.
by kawarider » Thu Feb 27, 2020 5:00 pm
Tried it today. Very nice! Thanks. Now and then this comes in very handy.
- kawarider
- Posts: 42
- Joined: Sun Jun 17, 2018 10:38 am
12 posts
• Page 2 of 2 • 1, 2
Return to General discussion about the UCCNC software
Who is online
Users browsing this forum: No registered users and 33 guests