Yes, the error message is a .NET framework error message. The error message is not generated by the UCCNC software, but the .NET framework. It is probably an error in the screenset file.
Unfortunately if you could not make the UCCNC modifications to work then there is very little to no chance that you will have luck with Mach4 and it's scripting language (Lua), because it is much more complicated.
But again, good luck to you, hopefully I will be wrong.
JIT enable option?
43 posts
• Page 5 of 5 • 1, 2, 3, 4, 5
Re: JIT enable option?
by cncdrive » Mon Dec 02, 2019 3:29 pm
- cncdrive
- Site Admin
- Posts: 4887
- Joined: Tue Aug 12, 2014 11:17 pm
Re: JIT enable option?
by Mario Soto » Fri Dec 06, 2019 1:27 pm
This is very good software and the support is always available. I would recommend it to anyone looking for a cnc controller.
- Mario Soto
- Posts: 40
- Joined: Sun Jun 10, 2018 8:24 pm
Re: JIT enable option?
by eabrust » Fri Dec 06, 2019 5:51 pm
Mario Soto wrote:This is very good software and the support is always available. I would recommend it to anyone looking for a cnc controller.
I fully agree, UCCNC is very good software with great support!
I thought the statement needed to be clarified a bit. 
CraftyCNC: Plugins for UCCNC (and other neat stuff): http://www.craftycnc.com/plugins-for-uccnc/
- eabrust
- Posts: 357
- Joined: Fri Sep 16, 2016 2:32 am
- Location: Near Shirland IL, USA
43 posts
• Page 5 of 5 • 1, 2, 3, 4, 5
Return to General discussion about the UCCNC software
Who is online
Users browsing this forum: Bing [Bot] and 8 guests