It is only possible if we will make it. Dan911 or anybody else could not do it as a plugin or macro, because they have no access to the motion planner algorithm of the UCCNC.
We have on our todo list, but I can't tell you yet when will we get to it.
Advice needed on actual cycle time against Est cycle time
12 posts
• Page 2 of 2 • 1, 2
Re: Advice needed on actual cycle time against Est cycle tim
by cncdrive » Mon Nov 04, 2019 10:16 pm
- cncdrive
- Site Admin
- Posts: 4887
- Joined: Tue Aug 12, 2014 11:17 pm
Re: Advice needed on actual cycle time against Est cycle tim
by rmtucker » Tue Nov 05, 2019 12:27 pm
Ok thank you for that.
For now i will get the estimated time from Mach3 which is not far away.
For now i will get the estimated time from Mach3 which is not far away.
- rmtucker
- Posts: 50
- Joined: Wed Aug 21, 2019 10:14 am
12 posts
• Page 2 of 2 • 1, 2
Return to General discussion about the UCCNC software
Who is online
Users browsing this forum: Bing [Bot] and 16 guests