Upto 400kHz step frequency operation UC300ETH
Posted: Mon Sep 25, 2017 6:58 pmWas wondering if the 400kHz is per axis or a total for all.
cheers
Alex
cheers
Alex
forum.cncdrive.com
UCCNC machine control software support forum
https://forum.cncdrive.com/
Upto 400kHz step frequency operation UC300ETH
Page 1 of 1
Posted: Mon Sep 25, 2017 6:58 pmRe: Upto 400kHz step frequency operation UC300ETH
Posted: Mon Sep 25, 2017 6:59 pmEach axis can output at 400Khz.
Re: Upto 400kHz step frequency operation UC300ETH
Posted: Mon Sep 25, 2017 8:44 pm400kHz per axis, I mean every axis can do 400kHz step frequency.
Re: Upto 400kHz step frequency operation UC300ETH
Posted: Tue Sep 26, 2017 8:29 amalex_s wrote:Was wondering if the 400kHz is per axis or a total for all.
cheers
Alex
Watch out for setting to 400kHz. If your drivers can't handle that (and most of them can't) then it will cause some missing steps and/or stalling.
Re: Upto 400kHz step frequency operation UC300ETH
Posted: Wed Sep 27, 2017 11:58 amA_Camera wrote:alex_s wrote:Was wondering if the 400kHz is per axis or a total for all.
cheers
Alex
Watch out for setting to 400kHz. If your drivers can't handle that (and most of them can't) then it will cause some missing steps and/or stalling.
the Servos and drives ask for a minimum of 125kHz, but if it is 400kHz per axis then all is fine
Thx ger21 and cncdrive for the confirmation.
cheers
Alex