forum.cncdrive.com

Hi there!

Couple of years ago I've purchased UCCNC bundle (software, UC300ETH-5LPT and UCBB).
That was "long story" project. Now I'm going to implement it in another CNC. And I've faced with output pins shortage. Actually - I need another 4 output pins, litteraly.

UC300ETH-5LPT has 5 "LPT Ports" and only 2 of them (Port1 and Port2) occupied by UCBB (CN2 and CN2) accordingly.
The question is: can I connect another .... "breakout board" from aliexpress to have a couple of IO pins in addition to UCBB.
To be more precise - I'm talking about this two types of chinese BOB
One
https://mega.nz/file/ufQnEBCZ#r1IZfaTRn ... nWtZhRX6UI
Two
https://mega.nz/file/XXAXBYDI#g5hoeuHOf ... wlCDlItGc0

Thanks in advance

Yes, you can.

ger21 wrote:Yes, you can.

Thanks ger21, just one more thing... Which port on UC300 I must use? Standart or bidirectional?

Regards...

Standard (Port 3?)

ger21 wrote:Standard (Port 3?)

My appreciation, ger21!