forum.cncdrive.com

Hi all,
New to this forum but have had a good browse with lots of insight.
I am waiting for delivery this week hopefully of UC300ETH-5LPT + UCBB breakout board.
I have looked through the manuals and tried to figure out the wiring for the UCBB with my limited knowledge of wiring diagrams.
I have attached a simplified diagram in the hope I can get some feedback, if I am on the correct path so that I am ready to install as soon as the BoB arrives.
Any help would be greatly appreciated.

Your wirings all look good.

Thanks for the reply. Good to be reassured of my initial thoughts.
The only thing I forgot was the probe, but I assume it is wired like the Estop.