UC300ETH-5LPT and Relays Configuration Help
Posted: Sat May 30, 2020 6:19 amhello, 
im newbe
Need some with uc300eth-5lpt. I want to temporary use (CNC Spindle Kit 500W Air Cooled 0.5kw Milling Motor + Spindle Speed Power Converter), but
don't know how to wire up this with a relay. i hive a +5v replay module and a +12v relay module. I'm not sure which one to use without burnout UC300.
Because the breakout is +5v output signal, Know sure if the +5v relay work configure. So i would like some advice before attempting to try this configuration. In the UCCNC software for the Spindle NO-> set to PIN 14 / PORT 2. didn't try this Yet!., need to make sure.
Will I really appreciate the help.. Thanks
This is my diagram wirning Now. Picture below:
im newbe
Need some with uc300eth-5lpt. I want to temporary use (CNC Spindle Kit 500W Air Cooled 0.5kw Milling Motor + Spindle Speed Power Converter), but
don't know how to wire up this with a relay. i hive a +5v replay module and a +12v relay module. I'm not sure which one to use without burnout UC300.
Because the breakout is +5v output signal, Know sure if the +5v relay work configure. So i would like some advice before attempting to try this configuration. In the UCCNC software for the Spindle NO-> set to PIN 14 / PORT 2. didn't try this Yet!., need to make sure.
Will I really appreciate the help.. Thanks
This is my diagram wirning Now. Picture below:
