forum.cncdrive.com

Posted: **Wed Mar 04, 2020 4:07 pm**

Hi all,

is there a way, to control and handle iHSV57 180W-Servos with UCCNC?

CU
Peter

Posted: **Wed Mar 04, 2020 4:22 pm**

They take step and direction signals, and are wired just like a stepper motor.

Posted: **Wed Mar 04, 2020 9:03 pm**

Thank you Gerry.

so adjust parameters, test and start milling :-)

CU
Peter

Posted: **Wed Mar 04, 2020 11:48 pm**

If they are servos then they might need PID tuning also, but that is not UCCNC related.

iHSV57 180W-Servos