forum.cncdrive.com

UCCNC machine control software support forum

Skip to content

iHSV57 180W-Servos

This Section is for users to discuss hardware
Post a reply

iHSV57 180W-Servos

Postby CADdy » Wed Mar 04, 2020 4:07 pm

Hi all,

is there a way, to control and handle iHSV57 180W-Servos with UCCNC?

CU
Peter
CADdy
 
Posts: 148
Joined: Sun Sep 17, 2017 2:26 pm
Top

Re: iHSV57 180W-Servos

Postby ger21 » Wed Mar 04, 2020 4:22 pm

They take step and direction signals, and are wired just like a stepper motor.
Gerry
UCCNC 2022 Screenset - http://www.thecncwoodworker.com/2022.html
ger21
 
Posts: 2714
Joined: Sat Sep 03, 2016 2:17 am
Top

Re: iHSV57 180W-Servos

Postby CADdy » Wed Mar 04, 2020 9:03 pm

Thank you Gerry.

so adjust parameters, test and start milling :-)

CU
Peter
CADdy
 
Posts: 148
Joined: Sun Sep 17, 2017 2:26 pm
Top

Re: iHSV57 180W-Servos

Postby cncdrive » Wed Mar 04, 2020 11:48 pm

If they are servos then they might need PID tuning also, but that is not UCCNC related.
cncdrive
Site Admin
 
Posts: 4887
Joined: Tue Aug 12, 2014 11:17 pm
Top
Post a reply

Return to Hardware

Who is online

Users browsing this forum: No registered users and 40 guests

Powered by phpBB® Forum Software © phpBB Group