Laser/spindle combo
23 posts
• Page 3 of 3 • 1, 2, 3
Re: Laser/spindle combo
by cncdrive » Sun Jun 03, 2018 4:47 pm
The polarity for the laser on is then probably the opposite for the laser as for the spindle on. (active low setting)
- cncdrive
- Site Admin
- Posts: 4887
- Joined: Tue Aug 12, 2014 11:17 pm
Re: Laser/spindle combo
by sngatlanta » Mon Jun 04, 2018 6:56 pm
cncdrive wrote:The polarity for the laser on is then probably the opposite for the laser as for the spindle on. (active low setting)
I switched the active Low setting for the I/O and the Spindle Active Low on and off, to all compinations and still the Laser is on when the Spindle ( M3 ) command is off. When given the m3 command to turn on the Spindle I regain control of the lasers m10 and m11 comands.
Any help is appreciated.
- sngatlanta
- Posts: 23
- Joined: Wed Jan 10, 2018 11:12 pm
- Location: Little Rock, AR USA
Re: Laser/spindle combo
by dezsoe » Mon Jun 04, 2018 7:10 pm
Could you upload your profile? There must be something misconfigured.
BTW, did the G52 work for you?
BTW, did the G52 work for you?
- dezsoe
- Posts: 2093
- Joined: Sun Mar 12, 2017 4:41 pm
- Location: Csörög, Hungary
23 posts
• Page 3 of 3 • 1, 2, 3
Who is online
Users browsing this forum: Bing [Bot] and 7 guests