Hi,
I've bought a BRKC-180; I need to change the triggering voltage.
I've read in another forum that is possible by chenging a resistor:
https://www.cncitalia.net/forum/viewtopic.php?f=88&t=53839&start=75#p549687
Someone can help me?
Thank you
change BRKC-180 triggering voltage
5 posts
• Page 1 of 1
change BRKC-180 triggering voltage
by taganaka75 » Wed Jun 07, 2023 1:34 pm
- taganaka75
- Posts: 3
- Joined: Thu Mar 30, 2023 9:01 pm
Re: change BRKC-180 triggering voltage
by cncdrive » Tue Jun 13, 2023 12:00 pm
Hi, I've attached the resistor values vs the trigger voltage levels chart.
- Attachments
-
- 0oap8MW1Xuc4C4ov.png (10.72 KiB) Viewed 3047 times
- cncdrive
- Site Admin
- Posts: 4887
- Joined: Tue Aug 12, 2014 11:17 pm
Re: change BRKC-180 triggering voltage
by taganaka75 » Thu Jun 15, 2023 7:25 am
Thank you for the chart.
can you show me which resistor need to be replaced on the board?
Thank you.
can you show me which resistor need to be replaced on the board?
Thank you.
- taganaka75
- Posts: 3
- Joined: Thu Mar 30, 2023 9:01 pm
Re: change BRKC-180 triggering voltage
by cncdrive » Fri Jun 16, 2023 11:26 pm
Those are the 2 THT resistors on the board closely next to eachother, all other resistors are SMD if I recall.
- cncdrive
- Site Admin
- Posts: 4887
- Joined: Tue Aug 12, 2014 11:17 pm
5 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 5 guests