Using Axbb BOB and uccnc to control sieg 2.7L mill

[Lucasclub]

If you’re looking to convert your mill to cnc operation ……..driven by uccnc ……you’ve stumbled on what has taken me 12 months to work out….enjoy.

Physical connection …spindle on/off , half speed and spindle speed using analogue input ……. Only need to cut 1 wire and solder 2 wires to achieve all of this but you will need to alter a couple of macros slightly …..

If you need more information on how…. PM me to start the conversation!

[cncdrive]

Maybe you should post your location.
At least the continent and country would be also helpful.