Hi guys,
Currently doing a retro fit on an older machine that is using analog drives and servos (Axor masterspeeds to be exact ) , they run fine and I would prefer to keep them if possible, is there anything out there that can convert the step / dir signal to an analog signal so that I can use these drivers. Thanks
Analog drives / servos? Is it possible
3 posts
• Page 1 of 1
Analog drives / servos? Is it possible
by Mcasey » Sun Apr 25, 2021 7:39 pm
- Mcasey
- Posts: 21
- Joined: Sun Apr 11, 2021 6:10 pm
Re: Analog drives / servos? Is it possible
by ger21 » Sun Apr 25, 2021 7:56 pm
Viper Step2Linear
http://www.viperservo.com/
http://www.viperservo.com/
Gerry
UCCNC 2022 Screenset - http://www.thecncwoodworker.com/2022.html
UCCNC 2022 Screenset - http://www.thecncwoodworker.com/2022.html
- ger21
- Posts: 2714
- Joined: Sat Sep 03, 2016 2:17 am
Re: Analog drives / servos? Is it possible
by Mcasey » Sun Apr 25, 2021 8:05 pm
Great stuff thanks ger21
- Mcasey
- Posts: 21
- Joined: Sun Apr 11, 2021 6:10 pm
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 13 guests