Maybe someone could explain to me what cause the issue that even if i have THC ON in G code, when pierce delay is 0,1 sec UCCNC giving out motion before plasma Arc is On. Shouldn't UCCNC wait for ARCON and only after this signal release motion? I have Arc on when Hypertherm is on with i bit of delay, but i guess UCCNC should wait no? Today I couldn't cut circles on my part because motion started before Plasma was on, and resulted a three-qourter circle not a full.
Any Idea?
Wait for ArcOn
2 posts
• Page 1 of 1
Wait for ArcOn
by attila0216 » Thu Nov 23, 2017 8:06 pm
- attila0216
- Posts: 15
- Joined: Wed Feb 08, 2017 11:37 pm
Re: Wait for ArcOn
by cncdrive » Fri Nov 24, 2017 4:36 am
Yes, UCCNC waits with the motion for the Arc on signal to be active, if the THC and M3 is active.
If the THC or M3 is inactive then it will not wait.
If the THC or M3 is inactive then it will not wait.
- cncdrive
- Site Admin
- Posts: 4901
- Joined: Tue Aug 12, 2014 11:17 pm
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 11 guests