z axis referencing
Posted: Sun Jan 10, 2021 5:41 pmHi all
Not sure if this is a sheetcam enquiry but here I go
I use uccnc along with a mini thc, when referencing with z axis for z 0
I have no way of slowing the feed rate to preset value say 5mm above the material is it possible to create code in sheetcam post to such
I have attached copy of my post processor
Any help is apricated
Not sure if this is a sheetcam enquiry but here I go
I use uccnc along with a mini thc, when referencing with z axis for z 0
I have no way of slowing the feed rate to preset value say 5mm above the material is it possible to create code in sheetcam post to such
I have attached copy of my post processor
Any help is apricated