forum.cncdrive.com

When XY movement stops, there is a 1+ sec delay before torch shuts off.
What could cause a delay that long?



Kristian

What is controlling the torch? The UCCNC via a motion controller pin controlled by a M3/M5 or via the Neuron or a combination of both?
If it is controlled by the UCCNC is what I can talk about is that if there is no M5 delay setup then there should be no more than a few tens of milliseconds delay.

If it's controlled by the Neuron then there may be a setting in the plugin which causing the delay, but please ask Andrew (Shad) about this.

Hello tonisson!
Please tell me, what plasma cutter do you use?

Powermax 85, but Olavi just said, that he sent email directly to you with the problem.



Kristian.

Yes Kristian, we try to check it today.