forum.cncdrive.com

I have developed a simple plugin to jog with a Saitek P2900 JoyPad.
Saitek P2900 JoyPad has two analog axes with a button for each, these buttons toggle the reset status.
With the analog axes you can jog with variable speed, from 0% to 100%.
The axes response is exponential so in the first part of travel the jog speed increase more slowly.
The Left axis jog XY and the Right axis jog only Z.
The plugin does not have any kind of configuration or UI and is made with Microsoft Visual Studio 2015 Community.

If you have a Saitek P2900 joypad or similar I'm happy if you wanna test my plugin. For the first few times I recommend to use Offline Mode

I cannot take responsibility for any personal injury and/or financial loss caused by any bugs in this plugin

Hi CarCan,

Does your plugin allow X and Y movement at same time with feedrate being variable for each?

I prefer to jog one axis at a time, I don't know if UCCNC permit to jog more than one axis at the same time. I will do a test