forum.cncdrive.com

First time post here.
I am a new user of UCCNC and just included a VIstaCNC P4-S Pendant. I have the UCCNC firmware loaded. I have the P4Spendant.dll in the UCCNC plug in directory.
However when I start UCCNC with the plugin enabled nothing happens when I click on the configuration button.
Has anyone else run into this? Any ideas what may be causing it?

By the way here are the specs
Windows 10
UCCNC 1.2049
UC300ETH
VistaCNC firmware 1.2 for UCCNC

Thanks
George M

Well I got an email from Lee at VistaCNC. The current plugin does not support the configuration window yet. Next version is supposed to do this.