forum.cncdrive.com

Would it be possible to have UCCNC square a slaved axis while homing, without having to adjust the switch position.
For example, you could add a Slave Offset value, so the position of the slave motor relative to it's home switch could be adjusted.
Or maybe just add a checkbox to use the slaved Home Offset value?

I realize that this can be done with a macro, but I think it's something that is easier done in software, than by moving the switches.

The macro terry wrote for me works really well. I agree though that this really should be on every control program that offers slaving.

Link to current macro (in case anyone reading this wants to find the macro).

viewtopic.php?f=15&t=42

Agreed, an offset for a slaved axis would be a useful field to add to the screenset.

bump.

If this won't happen, I'll integrate the macro into a future version of my screenset.