forum.cncdrive.com • View topic - Screw Mapping

Page 1 of 1

Screw Mapping

Posted: Thu Jun 09, 2022 6:30 am

by Toecutter

Hello,
Is it possible to add the screw mapping function to UCCNC as it is in Mach3?
Thanks & Greetings
Rene

Re: Screw Mapping

Posted: Thu Jun 09, 2022 11:36 am

by cncdrive

Yes, it is possible. But the UCCNC does not have this function.

Re: Screw Mapping

Posted: Thu Jun 09, 2022 11:37 am

by cncdrive

Yes, it is possible. But the UCCNC does not have this function. I'm not sure if and when we will add it.