Page 1 of 1
Double Click to reset toolpath view
Posted:
Mon Jan 02, 2017 3:32 pmby ger21
Can we get a double mouse click to reset the toolpath view to the default top view?
This would basically eliminate the need for all of the toolpath buttons.
Re: Double Click to reset toolpath view
Posted:
Mon Jan 02, 2017 4:30 pmby alex_s
ger21 wrote:Can we get a double mouse click to reset the toolpath view to the default top view?
This would basically eliminate the need for all of the toolpath buttons.
+++ less clutter is always good
Re: Double Click to reset toolpath view
Posted:
Tue Jan 03, 2017 12:51 amby cncdrive
Yes, we can do that.
Double mouse click -> Change to top view only or also change the scaling to the original "content zoom"?
Re: Double Click to reset toolpath view
Posted:
Tue Jan 03, 2017 1:05 amby ger21
Both, please.
Same as when loading a new file.
Re: Double Click to reset toolpath view
Posted:
Tue Jan 03, 2017 10:08 amby cncdrive
OK, I'll add this function.