forum.cncdrive.com

I would think it would be useful.

I would like a means of upgrading my profile when I install a new version of uccnc instead of overwriting the profile and resetting up all of the settings, that way I just setup anything new in the new version

Robertspark wrote:I would think it would be useful.

I would like a means of upgrading my profile when I install a new version of uccnc instead of overwriting the profile and resetting up all of the settings, that way I just setup anything new in the new version

I raised this question over a year ago but was down voted by a loud majority...
Anyway, I agree that it would be nice t have. The way it is now is a bit of a stone age and very primitive.