Table extents view

[dezsoe]

If you have your softlimits set up, show softlimits area enabled (config/appearance/workpiece... setup) and you turn on softlimits, then you will get a green (by default) border in the toolpath view. It is only in X-Y. Do you think of displaying the Z too?

[dezsoe]

Sorry, I don't understand. I didn't think of the workpiece grid but the display of softlimit borders. Normally, the softlimit is the size of your table. If the Z would be drawn too then you could see if the workpiece fits in your machine. Im I right?