s-curve motion profile

[ack1]

I have a big router and would really like to have this.

[ger21]

It's supposed to be the next big thing they work on...

[alex_s]

yep also waiting for it

[pupdogg]

@ger21 next thing they’re planning to work on or next thing that they’re actually working on? Any ETAs?

[ger21]

My understanding is after the next full release.
I'd expect a year or so, but I have no idea.

[cncdrive]

A joke comes to my mind about this question:

- Can you swim?
- No.
- And what if I pay you?



I mean it is impossible to give an ETA on something which we did not even start developing. We will only see the required time at least approximately when we will start doing the development, but then we still might encounter into issues which who knows how much time will take to fix etc. etc.
So, I don't think that it would be a good idea to promise an ETA yet.

[cncdrive]

And yes, Gerry is right, we will start working on it when we will reach a stable state of release with the current test version.
We also have some other minor developments before it, but maybe those will be done only after the S-curve, will see...

[cncdrive]

No, we don't want anybody to pay for any functions or features.
That joke was just about that when you doing new things, for example you don't know how to swim and you decide that you will learn swimming on your own and somebody asks you how much time it will take for you to learn it then you will be unable to give a time estamination, because you will have no idea how hard it is to learn swimming, because you can't swim and you have no experience with swimming.
The case is the same when developing new things. We have clear ideas and plans how to do things, but when implementing them we might encounter into problems which we did not think about in advance and so it would be too brave to give an ETA about something we did not do before.