forum.cncdrive.com

Hello.
I am new to edit Macro.
and hoping to get some help here in this forum
I have a Stepcraft M1000 where I have 10 Tools in my ATC.
and all tools are working when I am using the tool changing system.
But...
I have made a Extra Tool holder, there is different from the original Stepcraft tool holder, since I will have a bigger surface mill in my tool changer.
so I need to add an extra tool I my M6 Marco which can handle my Tool 11.
Tool 11 will have another z pickup and release point, and the sequence when picking up and releasing the tool also have to be deferent, since the tool have to retract in Y direction after picking it up and retuning to the tool holder in Y before releasing it.

lets say tool 11 have:
ToolX[11] = 75.0; // Tool11 X position
ToolY[11] = 1042.0; // Tool11 Y position
and the
Ztoolrelease = -87.0;
Ztoolpickup = -87.0;

i have added the M6 macro i am running the 10 tools in my ATC.

hoping someone can help me

will add some pictures later of the machine with tool holder 11.

Best regards Søren From Denmark

Here is some pictures of the machine with the tool holder for tool 11

My problem is solved.
A kind member helped me rewrite my macro.
Many thanks !

Best regards Søren

Teachable moment ...Can you post the solution...Thanks