DG4S-08020 drive—noisy

This Section is for users to discuss hardware

DG4S-08020 drive—noisy

Postby Chuck767 » Wed May 08, 2019 1:09 pm

Hi All,
I have three of these drives, DG4S-08020, on my Shizoka Mill. They are controlling Fanuc Servos with Fanuc encoders. I have a Warp9 ESS motion control and a C62, CNC4PC break out board. Running MACH3

The Y and Z axis operate smoothly and sound very good, the X axis hums a lot and is more jerky and generally noisy.

I used the CNCdrives tuning stick and thought I had all drives tuned about the same.

In MACH 3, all the Motors are tuned the same relative to speed and velocity, etc.

Could someone point me in the right direction in resolving this.?

Thank you,
Chuck
Chuck767
 
Posts: 22
Joined: Mon May 02, 2016 2:14 pm

Return to Hardware

Who is online

Users browsing this forum: No registered users and 2 guests