Soft limits

If you have a question about the software please ask it here.

Soft limits

Postby MarioChevelle » Wed Apr 17, 2019 5:44 pm

How do I set soft limits without the soft limits switch’s ???
I when to configuration, General settings then i check the box ( Enable soft limits) but it won’t move it’s says I’m on the limits
MarioChevelle
 
Posts: 7
Joined: Thu Apr 04, 2019 2:28 am

Re: Soft limits

Postby cncdrive » Wed Apr 17, 2019 5:59 pm

Remember that softlimits are in machine coordinates, because they have to be referenced to the machine table and not to the actual offset coordinate system!!!
cncdrive
Site Admin
 
Posts: 2704
Joined: Tue Aug 12, 2014 11:17 pm


Return to Ask a question from support here

Who is online

Users browsing this forum: Google [Bot] and 2 guests