I am a total newb when it comes to all of this so bear with me.
We have a chinese CNC Router that we swapped out the NC controller to a UC300ETH with the C76 and c77 boards from CNC4PC along with UCCNC software.
I designed this panel on Fusion 360 and when it cut the panel it cut off one of the corners of the panel. The cut off corner doesn't show up on the Fusion simulation or on the UCCNC screen when it's actually cutting.
Here is the public link to the file https://a360.co/2v1HFZk
Not sure how to attach the gcode file
Any thoughts on this?