Mach3 in Demo-Mode with License-file and UC300ETH

Forum for Discussing Mach3/4 related issues

Mach3 in Demo-Mode with License-file and UC300ETH

Postby xx0r » Fri Dec 07, 2018 2:19 pm

Hello guys,

Mach3 (Version R3.043.066) starts in demo-mode when selecting the UC300ETH. I copied the license-file in the Mach3-folder and it works fine with the parallel port selected. Mach3 shows my name in the "About"-section and it does not stop in gcode-line 500. With UC300ETH selected the milling process stops after 500 lines of code and it shows Demo in the "About"-Section. I downloaded Mach3 with the UC300ETH plugin from cncdrive.com.

I hope you can help, thanks in advance,
Simon
xx0r
 
Posts: 1
Joined: Fri Dec 07, 2018 2:06 pm

Re: Mach3 in Demo-Mode with License-file and UC300ETH

Postby cncdrive » Fri Dec 07, 2018 4:56 pm

You should contact the software vendor (Artsoft) about the issue, because the mach3 license keys have nothing to do with us, only they can help you with that.
cncdrive
Site Admin
 
Posts: 2360
Joined: Tue Aug 12, 2014 11:17 pm


Return to Mach3/4 Discussions

Who is online

Users browsing this forum: No registered users and 0 guests