UC400ETH with Mach3 Turn profile

This Section is for users to discuss hardware

UC400ETH with Mach3 Turn profile

Postby CyclopsNC » Thu Oct 18, 2018 3:08 am

For some reason UC400ETH doesnt work with the Mach3 default Turn profile although it does work with the Mill profile. I guess its nothing to do with the profiles but just changing the settings in the "Ports and Pins" dialog should get it to work.
Unless I'm wrong, Is this by design or I just have to run through the settings and UC400ETH should work anyway with the turn profile.
I have checked the settings in the Ports and Pins for the turn profile and don't seem to be doing much wrong over there.
CyclopsNC
 
Posts: 14
Joined: Fri Jun 29, 2018 1:41 pm

Re: UC400ETH with Mach3 Turn profile

Postby cncdrive » Thu Oct 18, 2018 4:36 am

It should work the same with the Mill and the Turn profiles.
cncdrive
Site Admin
 
Posts: 2293
Joined: Tue Aug 12, 2014 11:17 pm


Return to Hardware

Who is online

Users browsing this forum: No registered users and 3 guests