whb04l plugin problem

If you have a question about the software please ask it here.

whb04l plugin problem

Postby merlinogio » Sun Sep 09, 2018 5:46 pm

Hi all
i'm new of this forum. I install UCCNC n(1.2048) with HY12 (1.0012) and XHC(1.4) plugins on a core duo 1.8Mhz with UC400eth
All go well if i use Mdi Command
The pendant instead give me problem with JOG and button go well.
JOG problem.. selected the axis:
- in continous set don't give any movemet and HB04 Display don't move
- MPG COnt set don't give any movemet and HB04 Display go up and down correctly
- MPG Single set give a strange movement (a few foward a few backward when i went only foward or only backward) and HB04 Display go up and down correctly
- MPG Multi set go correctly Bacward (HB04 Display too) and give the same instable movement of single set when i go forward (hb04 Display go well)

please can you help me?

thanks in advance
Flavio
merlinogio
 
Posts: 11
Joined: Sat Sep 08, 2018 5:51 am

Re: whb04l plugin problem

Postby kig23 » Tue Sep 11, 2018 6:48 am

Hi Flavio,
if you don't know the HB04 has 2 versions. I suppose that cncdrive wrote the plugin for the first version. I know that they did a lot of hard work to write the plugin. I have the first version of HB04 and it works fine with uccnc. Maybe the second version of the HB04 didn't work correctly with uccnc. If I can give you some advice, just sale the hb04 and buy UCR201. UCR201 is better than HB04 and you don't have to worry about the technical support. Hope this info is helpful for you
kig23
 
Posts: 106
Joined: Sat Mar 31, 2018 6:58 am
Location: Italy

Re: whb04l plugin problem

Postby merlinogio » Sat Sep 22, 2018 7:42 am

Hi kig
many thanks for your suggestion
I think you are right because I've try to change pendant with a poor xbox360 of 20€ and all go well! don't lost a shot!..;)
much minor professional and elegant but it resolved...;)

thanks
flavio
merlinogio
 
Posts: 11
Joined: Sat Sep 08, 2018 5:51 am


Return to Ask a question from support here

Who is online

Users browsing this forum: No registered users and 5 guests