What is everyone using for TURN at present? Mach3, Mach4??

While UCCNC does not currently have a TURN Modual Here is the place to discuss your wants and wishes for TURN

Re: What is everyone using for TURN at present? Mach3, Mach4

Postby Vmax549 » Fri Jun 08, 2018 8:05 pm

NOPE I was WRONG it was a problem with X axis acceleration values. Mach3 was pushing teh values UP to over 8 times teh Max Acceleration . UCCNC firmware could not deal with that much error.

And seeing how Mach4 uses a lot of Mach3 code that problem may STILL be in MACH4. Or not :D

(;-) TP
Vmax549
 
Posts: 981
Joined: Sun Nov 22, 2015 3:25 am
Location: USA

Previous

Return to UCCNC TURN (CNC Lathe)

Who is online

Users browsing this forum: No registered users and 0 guests