Weerasak is considering offering a daughterboard for the UB1 breakout board, to use ports 4 and 5.
What features would you like to see on them?
Single port board, or 2 port board?
Mostly inputs, or mostly outputs?
NPN? PNP?
Robertspark wrote:Take note that ports 4 & 5 of the UC300 are LPT input ports on pins 2-9, hence output is not an option (as far as I'm aware unless the firmware is to change for the UC300)
ger21 wrote:This is what he's thinking of:
-Second Charge Pump.
-13 npn isolated inputs 24V.
-13 npn/pnp isolated inputs 5v/24V.
-8 sink output same as mother board
It's probably 5-6 months away, though.
ger21 wrote:This is what he's thinking of:
-Second Charge Pump.
-13 npn isolated inputs 24V.
-13 npn/pnp isolated inputs 5v/24V.
-8 sink output same as mother board
It's probably 5-6 months away, though.
ger21 wrote:A limited number of UB-1 daughterboards are now for sale at CNC Room. Not that there are two different versions.
http://www.cncroom.com/interface-cards/ ... anguage=en
Users browsing this forum: No registered users and 12 guests