programming dg4s
2 posts
• Page 1 of 1
programming dg4s
by paul mcgee » Thu Jan 04, 2018 9:10 pm
struggling to progamme dg4s with programming stick, sevo configerator3 conected to the first servo driver and i was able to down load pid settings, but it does not see the other sevo drivers when i try to conect and tune those, if i revert bact to the first servo driver it still conects to this, can you sugest were i am going wrong, thanks
- paul mcgee
- Posts: 11
- Joined: Thu Jan 04, 2018 8:53 pm
2 posts
• Page 1 of 1
Return to Ask a question from support here
Who is online
Users browsing this forum: Bing [Bot] and 4 guests