by cncdrive » Tue Nov 14, 2017 1:08 pm
I think what Dezsoe ment is that if your breakout board needs a charge pump signal as an enable signal then this method will not work, because the charge pump signal will still be missing, so the output the plugin or macroloop will output will be there on the output on the motion controller, but your breakout board will not throughput and use the signal, because the charge pump safety signal is missing when the UCCNC is in reset.
However you could change/reconfigure the method of how the charge pump signal acts, change it to always on and then the charge pump will not be removed on reset, only when the UCCNC is not running and then the plugin/macro method will work, because the charge pump will be always on when you running the UCCNC and so your breakout board will use the output signal.
However it is then a question if changing how the charge pump acts will cause any other problems for your system if the charge pump is always on, but this depends on how your system is wired and configured and what the charge pump signal does in your system....